Macroscopic— The fruits (achenes)are elongated ovoid,slightly crooked,somewhat flattened,roughly 6to 7mm in length,up to 3mm in width,and 1.5mm in thickness,and have a projecting cartilaginous glossy yellowish edge on the upper surface and a grooved hilum at the base.The fruit coat is glossy brown-black or mat gray-brown with dark or pale gray streaks;it encloses the straight embryo having two thick,flattened cotyledons that contain fatty oil and aleurone granules.

Microscopic— The fruit wall epidermis consists of almost colorless palisade cells arranged at right angles to the surface.They have greatly thickened outer walls,into which the lumen continues for some distance in the form of a slit.Viewed from above under high magnification,the cells show only a slit-shaped lumen.They have thickened ridges that appear as nodular thickenings of the cell wall when viewed from above.The subepidermal layer of the fruit wall is made up of unlignified thin-walled parenchymal cells and constitutes a pigment layer.Colorless cells and groups of cells alternate with pigment cells,the latter varying in number;this gives the fruit wall its mottled appearance.Next comes the fruit wall tissue,about 8cell layers thick,with stippled parenchymal cells elongated in the longitudinal axis of the fruit.The cells of the innermost layer of the fruit wall may be collapsed;they contain large cigar-shaped or monoclinic calcium oxalate prisms.The seed coat epidermis is formed from large yellow palisade cells.The cells have a narrow lumen,somewhat expanded at each end of the cell,and the cell walls show conspicuous lamination.The subepidermal cells of the seed coat consist of peculiar stippled cells;their lignified cell membranes have prominent,close-set ridges or thickenings (“net cells”).Next to them is a single layer of cells having tough,somewhat swollen walls and lipophilic contents (endosperm residue).The embryo consists of thin-walled cells which,in addition to small glands,contain clumps of crystals and fat droplets.

A: Thin-Layer Chromatographic Identification Test á201ñ—

B: The retention times of the peaks for silydianin,silychristin,silybin A,silybin B,isosilybin A,and isosilybin Bin the chromatogram of the Test solutioncorrespond to those in the chromatogram of the Milk thistle standard solution,as obtained in the test for Content of silymarin.

Solution A— Use a filtered and degassed mixture of water,methanol,and phosphoric acid (80:20:0.5).

Solution B— Use a filtered and degassed mixture of methanol,water,and phosphoric acid (80:20:0.5).

Mobile phase— Use a variable mixture of Solution Aand Solution Bas directed in the Chromatographic system.Make adjustments if necessary (see System Suitabilityunder Chromatography á621ñ).

Milk thistle standard solution— Dissolve an accurately weighed quantity of USP Powdered Milk Thistle Extract RSin methanol,sonicate for 20minutes,and dilute with methanol to obtain a solution having a known concentration of about 0.7mg of extract per mL.Transfer 1mLof this solution to a 5-mLvolumetric flask,and dilute with methanol to volume.Pass through a membrane filter having a 0.45-µm or finer porosity.

Silybin standard solutions— Dissolve an accurately weighed quantity of USP Silybin RSin methanol,and dilute with methanol to obtain solutions having known concentrations of about 0.20mg per mL,0.02mg per mL,and 0.004mg per mL,respectively.Pass through a membrane filter having a 0.45-µm or finer porosity.

Test solution— Transfer about 10g of finely powdered Milk Thistle,accurately weighed,to an extraction thimble,and cover with a small cotton ball.Transfer the thimble to a continuous-extraction apparatus fitted with a 250-mLround-bottom flask containing 150mLof solvent hexane,and heat the flask on a heating mantle for 4hours.Following the extraction,separate the round-bottom flask containing solvent hexane extract from the extraction apparatus,and discard the solvent hexane solution.Remove the adherent solvent hexane from the extraction thimble by drying,and transfer the thimble to an extraction apparatus suitable for hot extraction and fitted with a 250-mLround-bottom flask containing 100mLof ethyl acetate.[NOTE—Adjust the volume of ethyl acetate,if necessary,to sustain a continuous extraction.]Heat the flask on a heating mantle to allow the solvent to reflux gently.After 8hours,transfer the extract quantitatively into a 100-mLvolumetric flask,dilute with methanol to volume,and mix.Transfer 1.0mLof this solution to a 25-mLvolumetric flask,and dilute with methanol to volume.

Chromatographic system (see Chromatography á621ñ)— The liquid chromatograph is equipped with a 288-nm detector and a 4.6-mm ×15-cm column that contains 5-µm packing L1and is maintained at a temperature of 40.The flow rate is about 1.0mLper minute.The chromatograph is programmed as follows. Chromatograph the Milk thistle standard solution,and record the peak responses as directed for Procedure:the chromatogram obtained is similar to the Reference Chromatogram provided with the USP Powdered Milk Thistle Extract RS;the relative retention times are about 0.68for silychristin,0.73for silydianin,1.00for silybin A,1.05for silybin B,1.09for dehydrosilybin,1.15for isosilybin A,and 1.19for isosilybin B;the resolution factor,R,between silybin Aand silybin Bis not less than 1.0;the tailing factor is not less than 0.8and not more than 2.0;and the relative standard deviation for the sum of peak responses due to silybin Aand silybin Bis not more than 2.0%.

Procedure— Separately inject equal volumes (about 10µL)of the Milk thistle standard solution,each of the Silybin standard solutions,and the Test solutioninto the chromatograph,and record the chromatograms.Identify the peaks due to silychristin,silydianin,silybin A,silybin B,isosilybin A,and isosilybin Bby comparison with the chromatogram of the Milk thistle standard solution,and measure the peak areas of the relevant peaks.Plot the areas of the sum of silybin Aand silybin Bpeaks versus the concentration of USP Silybin RSin the Silybin standard solutions,and obtain a regression line for calibration.Separately calculate the percentage of each relevant component of silymarin as silybin (C25H22O10)in the portion of Milk Thistle taken by the formula: in which Cis the concentration,in mg per mL,of the relevant component in the Test solutionas interpolated in the calibration graph;and Wis the weight,in g,of the portion of Milk Thistle taken.Calculate the content of silymarin,in percentage,in the portion of Milk Thistle taken by adding the individual percentages.