Chemical and microbial components that can be found in drinking water meeting U.S.Environmental Protection Agency National Primary Drinking Water Regulations (or equivalent)can have the potential to produce significant negative effects in patients undergoing hemodialysis.It is,therefore,necessary to subject the water to further treatment to reduce these components to acceptable levels.The Water for Hemodialysismonograph provides bacterial and chemical tests that are required to ensure patient safety.Additional testing is recommended as follows:

Table 1.Maximum Allowable Chemical Levels in Water
for Hemodialysis (water used to prepare dialysate and con-
centrates from powder at a dialysis facility and to
reprocess dialyzers for multiple use)*

The chemical limits included in Table 1have been recognized by federal government agencies as standards for Water for Hemodialysis.Written standard operating procedures for water testing should be established by the physician in charge or the designated facility manager.The test frequency decision should be based upon historical data analysis,the quality of the source water as reported by the municipal water treatment facility or public health agency in the area,etc.Records should be maintained to document levels and any necessary action taken.

Chemical analysis of water components listed should be performed using methods referenced in the American Public Health Association's Standard Methods for the Examination of Water and Wastewater,19thEdition,1those referenced in the U.S.Environmental Protection Agency's Methods for the Determination of Metals in Environmental Samples,2or equivalent methods as described in ANSI/AAMI RD62:2001.

The Water for Hemodialysismonograph includes microbial limits of 100cfu per mLand endotoxin limits of 2USP Endotoxin Units per mL.Culture media should be tryptic soy agar or equivalent,and colonies should be counted after incubation at a temperature range between 30and 35,for no less than 48hours.Sampling the water should be done at the end of the water purification cascade at the point where the water enters the equipment.Quantification of bacterial endotoxins is performed using the Limulus Amebocyte Lysate (LAL)clotting method found in the USPgeneral test chapter Bacterial Endotoxins Test á85ñ.

Because of the incubation time required to obtain definitive microbiological results,water systems should be microbiologically monitored to confirm that they continue to produce water of acceptable quality.“Alert”and “Action Levels”are therefore necessary for the monitoring and control of the system.An Alert Level constitutes a warning and does not require a corrective action.An Action Level indicates a drift from normal operating conditions and requires that corrective action be taken.The recommended Action Level for total viable microbial count in the product water is 50cfu per mL,and the recommended Alert Level for bacterial endotoxins is 0.5USP Endotoxin Unit per mL(also see Microbial Considerationsunder Water for Pharmaceutical Purposes á1231ñ).