A: The retention time of the oxytocin peak in the chromatogram of the Assay preparationcorresponds to that in the chromatogram of the Standard preparationas obtained in the Assay.

B: Obtain the uterus from a 120-to 200-g rat in diestrus.Suspend one horn of the uterus in a bath at 32containing,in each liter of water,9.0g of sodium chloride,0.42g of potassium chloride,0.16g of calcium chloride,0.50g of sodium bicarbonate,0.25g of dextrose,and 0.0053g of magnesium chloride.Oxygenate the bath solution with a mixture of 95%oxygen and 5%carbon dioxide.Record the contractions of the muscle on a recorder,using an isotonic and linear transducer.Add to the bath two appropriate dilutions of USP Oxytocin RS,and record the contraction of the muscle following each dilution.The appropriate dilutions are determined to give clearly distinctive submaximal contractions.Replace the solution in the bath with a fresh solution,and wait until the muscle is relaxed.Dissolve or dilute the preparation to be tested in a suitable diluent to obtain responses on the addition of two doses similar to the one used with the Standard solution.The magnitude of the contractions obtained with the Standard solution is comparable to the contractions obtained with the test solution.

Mobile phase A— Prepare a buffer solution of 0.1Mmonobasic sodium phosphate.

Mobile phase B— Prepare a filtered and degassed mixture of acetonitrile in water (1:1).Make adjustments if necessary (see System Suitabilityunder Chromatography á621ñ).

Diluent— Dissolve 5.0g of chlorobutanol in 5.0mLof glacial acetic acid,add 5.0g of alcohol,1.1g of sodium acetate,and 1000mLof water,and mix.

Standard preparation— Dissolve the entire contents of a vial of USP Oxytocin RSin a known volume of Diluent.[NOTE—The solution may be diluted as necessary to a working concentration range for the assay.]

Assay preparation— Dissolve an accurately weighed quantity of Oxytocin in Diluentto obtain a solution containing about 10USP Oxytocin Units per mL.

Chromatographic system (see Chromatography á621ñ)— The liquid chromatograph is equipped with a variable wavelength detector set at 220nm and a 12.0-cm ×4.6-mm column that contains 5-µm packing L1,and is programmed to provide variable mixtures of Mobile phase Aand Mobile phase B.The column is maintained at room temperature,and the flow rate is about 1.5mLper minute.The system is equilibrated with a mixture of 70%Mobile phase Aand 30%Mobile phase B.After each injection of the Standard preparationand the Assay preparation,the composition of the mobile phase is changed linearly over the next 20minutes so that it consists of a mixture of 50%Mobile phase Aand 50%Mobile phase B.Chromatograph the Standard preparation,and record the chromatograms as directed for Procedure.Adjust the flow rate or the composition of the Mobile phasesuch that the retention time of oxytocin is approximately 10minutes and between 15and 17minutes for chlorobutanol.The resolution,R,between oxytocin and the nearest adjacent peak is not less than 1.5,and the relative standard deviation for replicate injections is not more than 2.0%for oxytocin.

Procedure— Separately inject three equal volumes (about 100µL)of the Assay preparationand the Standard preparationinto the chromatograph,and record the chromatograms as described under Chromatographic system.Identify the peaks,and determine the area of the oxytocin peak.Calculate the potency of oxytocin in USP Oxytocin Units per mg by the formula: in which Cis the concentration,in USP Oxytocin Units per mL,of the Standard preparation;and rUand rSare the mean peak responses obtained from the Assay preparationand the Standard preparation,respectively;Vis the volume of sample solution in which the sample was dissolved;and Wis the amount,in mg,of oxytocin dissolved in the sample solution.