Tetracycline Hydrochloride Tablets
»Tetracycline Hydrochloride Tablets contain not less than 90.0percent and not more than 125.0percent of the labeled amount of C22H24N2O8·HCl.
Packaging and storage— Preserve in tight,light-resistant containers.
Identification— The chromatogram of the Assay preparationobtained as directed in the Assayexhibits a major peak for tetracycline,the retention time of which corresponds to that exhibited in the chromatogram of the Standard preparation,obtained as directed in the Assay.
Dissolution á711ñ—
Medium: water;900mL.
Apparatus 2: 75rpm.Maintain a distance of 45±5mm between the blade and the inside bottom of the vessel.
Time: 60minutes.
Procedure— Determine the amount of C22H24N2O8·HCl dissolved from UVabsorbances at the wavelength of maximum absorbance at about 276nm of filtered portions of the solution under test,suitably diluted with Dissolution Medium,if necessary,in comparison with a Standard solution having a known concentration of USP Tetracycline Hydrochloride RSin the same Medium.
Tolerances— Not less than 80%(Q)of the labeled amount of C22H24N2O8·HCl is dissolved in 60minutes.
Uniformity of dosage units á905ñ: meet the requirements.
Loss on drying á731ñ— Dry about 100mg,accurately weighed,in vacuum at a pressure not exceeding 5mm of mercury at 60for 3hours:it loses not more than 3.0%of its weight.
Limit of 4-epianhydrotetracycline— Using the Diluting solvent,Chromatographic system,and Procedureset forth in the Assay,chromatograph a Standard solution prepared by dissolving an accurately weighed quantity of USP4-Epianhydrotetracycline Hydrochloride RSin Diluting solventto obtain a solution having a known concentration of about 15µg per mL.Using the chromatogram so obtained and the chromatogram of the Assay preparationobtained as directed in the Assay,calculate the percentage of 4-epianhydrotetracycline hydrochloride in the Tablets taken by the formula:
(10CE/T)(rU/rS),
in which CEis the concentration,in µg per mL,of USP4-Epianhydrotetracycline Hydrochloride RSin the Standard solution;Tis the quantity,in mg,of tetracycline hydrochloride in the portion of Tablets taken to prepare the Assay preparation,based on the labeled quantity;and rUand rSare the 4-epianhydrotetracycline peak responses obtained from the Assay preparationand the Standard solution,respectively:not more than 3.0%is found.
Assay—
Diluting solvent,Mobile phase,Standard preparation,Resolution solution,andChromatographic system— Prepare as directed in the Assayunder Tetracycline Hydrochloride.
Assay preparation— Weigh and finely powder not fewer than 20Tablets.Transfer an accurately weighed portion of the powder,equivalent to about 50mg of tetracycline hydrochloride,to a 100-mLvolumetric flask,add 50mLof Diluting solvent,mix,and sonicate for 5minutes.Allow to cool,add Diluting solventto volume,mix,and filter.
Procedure— Proceed as directed for Procedurein the Assayunder Tetracycline Hydrochloride.Calculate the quantity,in mg,of C22H24N2O8·HCl in the portion of Tablets taken by the formula:
(CP/10)(rU/rS),
in which the terms are as defined therein.
Auxiliary Information— Staff Liaison:William W.Wright,Ph.D.,Scientific Fellow
Expert Committee:(PA7)Pharmaceutical Analysis 7
USP28–NF23Page 1890
Phone Number:1-301-816-8335
Return